Dell Force10 C300 FTOS Command Line Reference Guide FTOS 8.4.2.7 E-Series Tera - Page 629
ip udp-broadcast-address, ip udp-helper udp-port
View all Dell Force10 C300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 629 highlights
ip udp-broadcast-address e Configure an IP UDP address for broadcast. Syntax ip udp-broadcast-address address To delete the configuration, use the no ip udp-broadcast-address address command. Parameters address Enter an IP broadcast address in dotted decimal format (A.B.C.D). Defaults Not Configured Command Modes INTERFACE (config-if) Usage Information When a UDP broadcast packet is flooded out of an interface, and the outgoing interface is configured using this command, the outgoing packet's IP destination address is replaced with the configured broadcast address. Related Commands debug ip udp-helper show ip udp-helper Enable debug and display the debug information on a console. Display the configured UDP helper(s) on all interfaces. ip udp-helper udp-port e Enable the UDP broadcast feature on an interface either for all UDP ports or a specified list of UDP ports. Syntax ip udp-helper udp-port [udp-port-list] To disable the UDP broadcast on a port, use the no ip udp-helper udp-port [udp-port-list] command. Parameters udp-port-list (OPTIONAL) Enter up to 16 comma separated UDP port numbers. Note: If this option is not used, all UDP Ports are considered by default. Defaults No default behavior or values Command Modes INTERFACE (config-if) Usage Information If the ip helper-address command and ip udp-helper udp-port command are configured, the behavior is that the UDP broadcast traffic with port numbers 67/68 will be unicast relayed to the DHCP server per the ip helper-address configuration. This will occur regardless if the ip udp-helper udp-port command contains port numbers 67/68 or not. If only the ip udp-helper udp-port command is configured, all the UDP broadcast traffic is flooded, including ports 67/68 traffic if those ports are part of the udp-port-list. Related Commands ip helper-address debug ip udp-helper show ip udp-helper Configure the destination broadcast or host address for DHCP server. Enable debug and display the debug information on a console. Display the configured UDP helper(s) on all interfaces. Interfaces | 629