Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 1019

Task Command Syntax FTOS#show vlan Codes: * - Default VLAN, G - GVRP VLANs NUM * 1 2 3 4 5 6 Status Inactive Active Active Active Active Active Q Ports U So 9/4-11 U Gi 0/1,18 U Gi 0/2,19 T Gi 0/3,20 U Po 1 U Gi 0/12 U So 9/0 Command Mode A VLAN is active only if the VLAN contains interfaces and those interfaces are up. VLAN 1 is inactive because it contains the interfaces that are not up. When you delete a VLAN (no interface vlan vlan-id), any interfaces assigned to that VLAN are reassigned to the default VLAN as untagged. Assign Interfaces to VLANs A port may either be an untagged member of a single VLAN, or a tagged member of perhaps multiple VLANs. • Untagged Ports - ports that do not append an 802.1Q VLAN tag to frames on egress, and do not accept tagged frames on ingress (tagged frames are dropped). Untagged ports must be connected to VLAN-unaware devices. • Tagged Ports - ports that append an 802.1Q tag to frames on egress, and accept only tagged frames on ingress (untagged frames are dropped). Tagged ports must be connected to VLAN-aware devices. When you place configure an enabled port as a switchport, the port is placed in the default VLAN. To remove a switchport from the default VLAN, remove the switchport configuration. To move the port to another VLAN, add it to the desired VLAN as either a tagged or untagged member. Step 1 2 Task Command Syntax Assign a switchport to a VLAN. [tagged | untagged] interface FTOS(conf)#int vlan 4 FTOS(conf-if-vlan)#tagged po 1 FTOS(conf-if-vlan)#show conf ! interface Vlan 4 no ip address tagged Port-channel 1 Display all switchports and the show vlan VLANs of which they are members. Command Mode INTERFACE VLAN EXEC Privilege VLAN | 1019