Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 461

To view current bindings, use the show hosts command. FTOS>show host Default domain is force10networks.com Name/address lookup uses domain service Name servers are not set Host Flags TTL Type -------- ----- ---- ---- ks (perm, OK) - IP patch1 (perm, OK) - IP tomm-3 (perm, OK) - IP gxr (perm, OK) - IP f00-3 (perm, OK) - IP FTOS> Address ------2.2.2.2 192.68.69.2 192.68.99.2 192.71.18.2 192.71.23.1 To view the current configuration, use the show running-config resolve command. Specify local system domain and a list of domains If you enter a partial domain, FTOS can search different domains to finish or fully qualify that partial domain. A fully qualified domain name (FQDN) is any name that is terminated with a period/dot. FTOS searches the host table first to resolve the partial domain. The host table contains both statically configured and dynamically learnt host and IP addresses. If FTOS cannot resolve the domain, it tries the domain name assigned to the local system. If that does not resolve the partial domain, FTOS searches the list of domains configured To configure a domain name, use the following command in the CONFIGURATION mode: Command Syntax ip domain-name name Command Mode CONFIGURATION Purpose Configure one domain name for the E-Series To configure a list of domain names, use the following command in the CONFIGURATION mode: Command Syntax ip domain-list name Command Mode CONFIGURATION Purpose Configure names to complete unqualified host names. Configure this command up to 6 times to specify a list of possible domain names. FTOS searches the domain names in the order they were configured until a match is found or the list is exhausted. IPv4 Addressing | 461