Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 669

Command Example: ip ospf intervals FTOS(conf)#int gi 2/2 FTOS(conf-if-gi-2/2)#ip ospf hello-interval 20 FTOS(conf-if-gi-2/2)#ip ospf dead-interval 80 FTOS(conf-if-gi-2/2)# OSPF Configuration with intervals set FTOS (conf-if-gi-2/2)#ip ospf dead-interval 20 FTOS (conf-if-gi-2/2)#do show ip os int gi1/3 GigabitEthernet 2/2 is up, line protocol is up Internet Address 20.0.0.1/24, Area 0 Process ID 10, Router ID 1.1.1.2, Network Type BROADCAST, Cost: 1 Transmit Delay is 1 sec, State DR, Priority 1 Designated Router (ID) 1.1.1.2, Interface address 30.0.0.1 Backup Designated Router (ID) 1.1.1.1, Interface address 30.0.0.2 Timer intervals configured, Hello 20, Dead 80, Wait 20, Retransmit 5 Hello due in 00:00:04 Neighbor Count is 1, Adjacent neighbor count is 1 Adjacent with neighbor 1.1.1.1 (Backup Designated Router) FTOS (conf-if-gi-2/2)# For more information regarding this functionality or for assistance, go to www.force10networks.com/ support. Configuration Requirements The interfaces must be in Layer-3 mode (assigned an IP address) and enabled so that they can send and receive traffic. The OSPF process must know about these interfaces. To make the OSPF process aware of these interfaces, they must be assigned to OSPF areas. OSPF must be configured GLOBALLY on the system in CONFIGURATION mode. OSPF features and functions are assigned to each router using the CONFIG-INTERFACE commands for each interface. Note: By default, OSPF is disabled. Open Shortest Path First (OSPFv2 and OSPFv3) | 669