Dell Force10 E600i FTOS Version 8.4.1.5 Configuration Guide for ExaScale - Page 865

FTOS(conf)#username john privilege 8 password john FTOS(conf)#enable password level 8 notjohn FTOS(conf)#privilege exec level 8 configure FTOS(conf)#privilege config level 8 snmp-server FTOS(conf)#end FTOS#show running-config Current Configuration ... ! hostname Force10 ! enable password level 8 notjohn enable password force10 ! username admin password 0 admin username john password 0 john privilege 8 ! privilege exec level 8 configure privilege configure level 8 snmp-server ! The following example is a screen shot of the Telnet session for user "john". The show privilege command output confirms that "john" is in privilege level 8. In the EXEC Privilege mode, "john" can access only the commands listed. In CONFIGURATION mode, "john" can access only the snmp-server commands. apollo% telnet 172.31.1.53 Trying 172.31.1.53... Connected to 172.31.1.53. Escape character is '^]'. Login: john Password: FTOS#show priv Current privilege level is 8 Force10#? configure Configuring from terminal disable Turn off privileged commands enable Turn on privileged commands exit Exit from the EXEC no Negate a command show Show running system information terminal Set terminal line parameters traceroute Trace route to destination FTOS#confi Force10(conf)#? end Exit from Configuration mode exit Exit from Configuration mode no Reset a command snmp-server Modify SNMP parameters FTOS(conf)# Security | 865