Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 1040

www.dell.com | support.dell.com Task Reload a stack-unit Reload a member unit, from the unit itself Reset a stack-unit when the unit is in a problem state. Command Syntax reset stack-unit 0-7 reset-self reset stack-unit 0-7 hard Command Mode EXEC Privilege EXEC Privilege EXEC Privilege Monitor an S-Series Stack with SNMP S-Series supports the following tables in f10-ss-chassis.mib for stack management through SNMP: • chStackUnitTable • chSysStackPortTable Troubleshoot an S-Series Stack • Recover from Stack Link Flaps on page 1040 • Recover from a Card Problem State on an S-Series Stack on page 1041 • Recover from a Card Mismatch State on an S-Series Stack on page 1041 Recover from Stack Link Flaps S-Series Stack Link Integrity Monitoring enables units to monitor their own stack ports, and disable any stack port that flaps five times within 10 seconds. FTOS displays console messages the local and remote members of a flapping link, and on the primary and secondary management units as KERN-2-INT messages if the flapping port belongs to either of these units. In Figure 50-21, a stack-port on the manager flaps. The remote member, Member 2, displays a console message, and the manager and standby display KERN-2-INT messages. To re-enable the downed stack-port, power cycle the offending unit. 1040 | Stacking S-Series Switches