Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 345

Command Syntax clear frrp Command Mode Purpose EXEC PRIVELEGED Clear the counters associated with all FRRP groups Show FRRP configuration Use the following command to view the configuration for the FRRP group. Command Syntax show configuration Command Mode CONFIG-FRRP Purpose Show the configuration for this FRRP group Show FRRP information Use one of the following commands show general FRRP information. Command Syntax show frrp ring-id show frrp summary Command Mode EXEC or EXEC PRIVELEGED EXEC or EXEC PRIVELEGED Purpose Show the information for the identified FRRP group. Ring ID: 1-255 Show the state of all FRRP groups. Ring ID: 1-255 Troubleshooting FRRP Configuration Checks • Each Control Ring must use a unique VLAN ID. • Only two interfaces on a switch can be Members of the same Control VLAN. • There can be only one Master node for any FRRP Group. • FRRP can be configured on Layer 2 interfaces only. • Spanning Tree (if enabled globally) must be disabled on both Primary and Secondary interfaces when FRRP is enabled. • When the interface ceases to be a part of any FRRP process, if Spanning Tree is enabled globally, it must be enabled explicitly for the interface. • The maximum number of rings allowed on a chassis is 255. Sample Configuration and Topology Force10 Resilient Ring Protocol | 345