Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 69

Note: You cannot use the change directory (cd) command until ftp-server topdir is configured. Display your FTP configuration using the command show running-config ftp from EXEC Privilege mode, as shown in Figure 4-4. Configure FTP client parameters When the system will be an FTP client, configure FTP client parameters: Task Specify a source interface. Configure a password. Enter username to use on FTP client. Command Syntax Command Mode ip ftp source-interface interface ip ftp password password ip ftp username name CONFIGURATION CONFIGURATION CONFIGURATION Display the FTP configuration using the command show running-config ftp from EXEC Privilege mode, Figure 4-4 Terminal Lines You can access the system remotely and restrict access to the system by creating user profiles. The terminal lines on the system provide different means of accessing the system. The console line (console) connects you through the Console port in the RPMs. The virtual terminal lines (VTY) connect you through Telnet to the system. The auxiliary line (aux) connects secondary devices such as modems. Deny and Permit Access to a Terminal Line Force 10 recommends applying only standard ACLs to deny and permit access to VTY lines. • Layer 3 ACL deny all traffic that is not explicitly permitted, but in the case of VTY lines, an ACL with no rules does not deny any traffic. • You cannot use show ip accounting access-list to display the contents of an ACL that is applied only to a VTY line. To apply an IP ACL to a line: Task Apply an ACL to a VTY line. Command Syntax ip access-class access-list Command Mode LINE To view the configuration, enter the show config command in the LINE mode, as shown in Figure 4-5. System Management | 69