Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 499

Assign a Static IPv6 Route c e s IPv6 Static Routes are supported on platforms Use the ipv6 route command to configure IPv6 static routes. Command Syntax ipv6 route prefix type {slot/ port} forwarding router tag Command Mode CONFIGURATION Purpose Set up IPv6 static routes prefix: IPv6 route prefix type {slot/port}: interface type and slot/port forwarding router: forwarding router's address tag: route tag Enter the keyword interface followed by the type of interface and slot/port information: • For a 10/100/1000 Ethernet interface, enter the keyword GigabitEthernet followed by the slot/ port information. • For a Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 10 Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a loopback interface, enter the keyword loopback followed by the loopback number • For a linecard interface, enter the keyword linecard followed by the slot number • For a port-channel interface, enter the keyword port-channel followed by the port-channel number • For a VLAN interface, enter the keyword vlan followed by the VLAN ID • For a Null interface, enter the keyword null followed by the Null interface number Telnet with IPv6 c e s IPv6 Telnet is supported on platforms The Telnet client and server in FTOS support IPv6 connections. You can establish a Telnet session directly to the router using an IPv6 Telnet client, or an IPv6 Telnet connection can be initiated from the router. Note: Telnet to link local addresses is not supported. IPv6 Addressing | 499