Dell Force10 S25N-S50N FTOS Configuration Guide FTOS 8.4.2.7 E-Series TeraScal - Page 435

To add a port channel to a VLAN, use either of the following commands: Command Syntax tagged port-channel id number untagged port-channel id number Command Mode Purpose INTERFACE VLAN INTERFACE VLAN Add the port channel to the VLAN as a tagged interface. An interface with tagging enabled can belong to multiple VLANs. Add the port channel to the VLAN as an untagged interface. An interface without tagging enabled can belong to only one VLAN. To remove a port channel from a VLAN, use either of the following commands: Command Syntax no tagged port-channel id number no untagged port-channel id number Command Mode Purpose INTERFACE VLAN Remove the port channel with tagging enabled from the VLAN. INTERFACE VLAN Remove the port channel without tagging enabled from the VLAN. To see which port channels are members of VLANs, enter the show vlan command in the EXEC Privilege mode. Assign an IP address to a port channel You can assign an IP address to a port channel and use port channels in Layer 3 routing protocols. To assign an IP address, use the following command in the INTERFACE mode: Command Syntax Command Mode Purpose ip address ip-address mask [secondary] INTERFACE Configure an IP address and mask on the interface. • ip-address mask: enter an address in dotted-decimal format (A.B.C.D) and the mask must be in slash format (/24). • secondary: the IP address is the interface's backup IP address. You can configure up to eight secondary IP addresses. Delete or disable a port channel To delete a port channel, you must be in the CONFIGURATION mode and use the no interface portchannel channel-number command. When you disable a port channel (using the shutdown command) all interfaces within the port channel are operationally down also. Interfaces | 435