Dell Inspiron 1318 Dell™ Technology Guide - Page 278

P R O G R A M - Enter the system setup program and correct the date or time (see "Entering the System Setup Program" on page 308). If the problem persists, replace the CMOS battery. TI M E - O F - D A Y N O T S E T - P L E A S E R U N T H E S YS T E M S E T U P P R O G R A M - Enter the system setup program and correct the date or time (see "Entering the System Setup Program" on page 308). If the problem persists, replace the CMOS battery. TI M E R C H I P C O U N T E R 2 F A I L E D - Run the Dell Diagnostics (see "Running the Dell Diagnostics" on page 281). THE AC POWER ADAPTER TYPE CANNOT BE DETERMINED. THE SYSTEM CAN ONLY BOOT WITH A 130-W POWER ADAPTER OR GREATER. STRIKE THE F1 KEY TO S H U T D O W N . - Connect a 130-W or greater AC adapter to the computer or docking station. NOTE: This message concerning the requirement of an AC power adapter type of 130-W or greater applies to laptop computers that require a 130-W or greater AC adapter. THE AC POWER ADAPTER WATTAGE AND TYPE CANNOT BE DETERMINED. THE BATTERY MAY NOT CHARGE. THEY SYSTEM WILL ADJUST THE PERFORMANCE TO MATCH THE POWER AVAILABLE. PLEASE CONNECT A DELL XXX-W AC ADAPTER OR GREATER FOR BEST SYSTEM PERFORMANCE. STRIKE THE F3 KEY (BEFORE THE F1 OR F2 KEY) IF YOU DO NOT WANT TO SEE POWER WARNING MESSAGES AGAIN. STRIKE T H E F 1 K E Y T O C O N T I N U E , F 2 T O R U N T H E S E T U P U T I L I T Y. - Connect the correct AC adapter to the computer or docking station. THE COMPUTER IS DOCKED AND ONLY BATTERY POWER IS DETECTED. THIS CAN HAPPEN IF THE POWER ADAPTER IS MISSING, THE POWER CORD IS UNPLUGGED, OR THE COMPUTER IS NOT PROPERLY CONNECTED TO THE DOCKING STATION. YOU SHOULD UNDOCK, REDOCK, ATTACH THE POWER ADAPTER, OR PLUG IN THE POWER CORD. STRIKE THE F1 KEY TO SHUTDOWN. THE AMOUNT OF SYSTEM MEMORY HAS CHANGED. IF YOU DID NOT CHANGE YOUR MEMORY... TO RESOLVE THIS ISSUE, TRY TO RESEAT THE MEMORY. STRIKE THE F1 KEY TO CONTINUE, F2 TO RUN THE SETUP UTILITY. PRESS F5 TO RUN ONBOARD DIAGNOSTICS. - • Reseat the memory (for instructions, see your computer's Service Manual). • If memory was not removed or installed, memory module or system board failure may have occurred. Contact Dell for assistance (see "Contacting Dell" on page 337). U N S U P P O R T E D M E M O R Y. S T R I K E T H E F 1 K E Y T O S H U T D O W N . - Ensure that the memory you are using is supported by your computer (see the documentation shipped with your computer). WARNING: A XXX-W AC ADAPTER HAS BEEN DETECTED, WHICH IS LESS THAN 278 Troubleshooting