Dell Latitude CSx H Service Manual - Page 10

Advanced Port Replicator APR, undock the computer. - battery

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44

2
Dell Latitude CS Portable Computers Service Manual
5HFRPPHQGHG±7RROV
Most of the procedures in this manual require the use of one or more of the
following tools:
´
#0 and #1 magnetized Phillips-head screwdrivers
´
Small flat-blade screwdriver
´
5-mm socket wrench
´
7-mm socket wrench
´
Small plastic scribe
3UHSDULQJ±WR±:RUN±,QVLGH±<RXU±&RPSXWHU
Before you start to work on the computer, perform the following steps:
1.
Save any work in progress and close all open application programs.
2.
Turn off the computer and any attached peripherals.
NOTE: Make sure that the computer is turned off and not in suspend-to-
disk mode (S2D). If you cannot shut down the computer using its operating
system, press the power button for 4 seconds.
3.
If the computer is docked in a C/Dock Expansion Station or C/Port
Advanced Port Replicator (APR), undock the computer.
4.
Disconnect the computer and any attached peripherals from their electrical
outlets to reduce the potential for personal injury or shock. Also disconnect
any telephone or telecommunications lines from the computer.
5.
Remove the power cable.
6.
Disconnect all other external cables from the computer.
7.
Remove any installed PC Cards.
127,&(±²0DNH²VXUH²WKDW²WKH²ZRUN²VXUIDFH²LV²FOHDQ²WR²SUHYHQW²VFUDWFKµ
LQJ²WKH²FRPSXWHU²FRYHU³
127,&(±²7R²DYRLG²GDPDJLQJ²WKH²V\VWHP²ERDUG´²\RX²PXVW²UHPRYH²WKH²
PDLQ²EDWWHU\²EHIRUH²\RX²VHUYLFH²WKH²FRPSXWHU³
8.
Turn the computer over so the battery is on the lower right corner of the
computer, and remove the main battery assembly from the battery bay.
Slide the battery bay latch toward the right side of the computer to push
the back side of the battery up out of the battery bay (see
Figure 2).