Dell N3200-ON EMC Networking N-Series Switches User Guide version 6.6.3 - Page 244

Basic Network Information Configuration Examples Configuring Network Information Using the OOB Port In this example, an administrator at a Dell office in California decides not to use the Dell Easy Setup Wizard to perform the initial switch configuration. The administrator configures Dell EMC Networking N2200-ON, N3000EON, N3100-ON and N3200-ON Series switches to obtain information from a DHCP server on the management network and creates the administrative user with read/write access. The administrator also configures the following information: • Primary DNS server: 10.27.138.20 • Secondary DNS server: 10.27.138.21 • Default domain name: sunny.dell.com The administrator also maps the administrative laptop host name to its IP address. The administrator uses the OOB port to manage the switch. To configure the switch: NOTE: Dell EMC Networking N1100-ON, N1500, N2000, and N2100-ON Series switches do not have an out-of-band interface. 1 Connect the OOB port to the management network. DHCP is enabled by on the switch OOB interface by default on Dell EMC Networking N3000E-ON, N3100-ON, and N3200-ON Series switches. DHCP is enabled on VLAN 1 on the Dell EMC Networking N1100ON/N1500/N2000/N2100-ON Series switches as they do not support an OOB interface. If the DHCP client on the switch has been disabled, use the following commands to enable the DHCP client on the OOB port. console#configure console(config)#interface out-of-band console(config-if)#ip address dhcp console(config-if)#exit 2 Configure the administrative user. console(config)#username admin password secret123 privilege 15 244 Setting Basic Network Information