Dell OptiPlex 3020M Dell OptiPlex 3020M Owners Manual - Page 30
Installing the PS2 and Serial Connector Board, Removing the WLAN Card, cover
View all Dell OptiPlex 3020M manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
Installing the PS2 and Serial Connector Board 1. Place the PS2 and serial connector board into its slot. 2. Tighten the screws that secure the PS2 and serial connector board to the base panel. 3. Connect the cable to the PS2 and serial connector board. 4. Install the cover. 5. Follow the procedures in After Working Inside Your Computer. Removing the WLAN Card 1. Follow the procedures in Before Working Inside Your Computer. 2. Remove the: a. cover b. hard drive 3. Perform the following steps as shown in the illustration: a. Remove the screw that secures the WLAN card to the system board [1]. b. Remove the WLAN bracket from the system board [2]. c. Disconnect the WLAN cables [3]. d. Slide the WLAN card from the system board [4]. Installing the WLAN Card 1. Align and place the WLAN card on the connector. 2. Connect the WLAN cables. 3. Place the WLAN bracket into its slot. 4. Tighten the screws to secure the WLAN card to the system board. 5. Install: a. hard drive b. cover 6. Follow the procedures in After Working Inside Your Computer. 30