Dell OptiPlex 3046 Small Form Factor Small Form Factor Owners Manual - Page 18
Installing the heat sink assembly, Removing the processor
View all Dell OptiPlex 3046 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 18 highlights
a Disconnect the heat sink cable from the system board. [1] b Loosen the captive screws that secure the heat sink assembly in sequential order [2] [3] [4] [5] and lift it away from the computer [6]. Installing the heat sink assembly 1 Place the heat sink assembly onto the processor. 2 Tighten the captive screws in sequential order to secure the heat sink assembly to the system board. 3 Connect the heat sink cable to the system board. 4 Install the: a fan duct b cover 5 Follow the procedure in After Working Inside Your Computer. Removing the processor 1 Follow the procedure in Before Working Inside Your Computer. 2 Remove the: a cover b fan duct c heat sink 3 To remove the processor: a Release the socket lever by pushing the lever down and out from under the tab on the processor shield [1]. b Lift the lever upward and lift the processor shield [2]. c Lift the processor out of the socket [3]. 18 Removing and installing components