Dell OptiPlex 3046 Small Form Factor Small Form Factor Owners Manual - Page 24
Installing the system board
View all Dell OptiPlex 3046 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
5 To remove the system board: a Remove the screws that secure the system board to the computer [1]. b Slide the system board toward the front of the computer and lift it from the computer [2]. Installing the system board 1 Hold the system board by its edges and angle it toward the back of the computer. 2 Lower the system board into the computer until the connectors at the back of the system board align with the slots on the back wall of the computer, and the screw holes on the system board align with the standoffs on the computer. 3 Tighten the screws that secure the system board to the computer. 4 Connect the cables to the system board. 5 Install the: a VGA daughter board b SD card reader c expansion card d processor e heat sink f optical drive 24 Removing and installing components