Dell OptiPlex 3046 Small Form Factor Small Form Factor Owners Manual - Page 19
Installing the processor, Removing the VGA daughter board, Installing the VGA daughter board
![]() |
View all Dell OptiPlex 3046 Small Form Factor manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Installing the processor 1 Align the processor with the socket keys. 2 Align the pin-1 indicator of the processor with the triangle on the socket. 3 Place the processor on the socket such that the slots on the processor align with the socket keys. 4 Close the processor shield by sliding it under the retention screw. 5 Lower the socket lever and push it under the tab to lock it. 6 Install the: a heat sink b fan duct c cover 7 Follow the procedure in After Working Inside Your Computer. Removing the VGA daughter board 1 Follow the procedure in Before Working Inside Your Computer. 2 Remove the: a cover b fan duct 3 To remove the VGA daughter board: a Remove the screws that secure the VGA connector to the computer [1]. b Slide the VGA connector to release it from the computer [2]. c Remove the screw that secures the VGA daughter board to the computer [3]. d Lift the VGA daughter board using the handle to remove it from the computer [4]. Installing the VGA daughter board 1 Align the VGA daughter board with the screw holder on the system board. 2 Tighten the screw to secure the VGA daughter board to the system board. 3 Insert the VGA connector into the slot at the back of the computer. 4 Tighten the screws to secure the VGA connector to the computer. 5 Install the: a fan duct b cover 6 Follow the procedure in After Working Inside Your Computer. Removing and installing components 19
![](/manual_guide/products/dell-optiplex-3046-small-form-factor-owners-manual-b0b8b4a/19.png)