Dell OptiPlex 330 User's Guide - Page 235
Remove the four shoulder screws from the existing drive., If you are replacing an existing drive
View all Dell OptiPlex 330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 235 highlights
NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer. 7 Connect your computer and devices to electrical outlets, and then turn them on. 8 Check the system setup for the appropriate diskette Drive Option changes (see "Entering System Setup" on page 79). Installing a Floppy Drive 1 Follow the procedures in "Before You Begin" on page 143. 2 Remove the computer cover (see "Removing the Computer Cover" on page 209). 3 If you are installing a new drive: a Gently slide a small flat-edge screw driver between the front of the computer and the back side of the drive-panel insert to pop off the insert. b Remove the four shoulder screws from the back of the drive-panel insert. 4 If you are replacing an existing drive: Remove the four shoulder screws from the existing drive. 5 Insert the four shoulder screws into the sides of the new floppy drive and tighten them. 6 Attach the power and data cables to the floppy drive. 7 Gently slide the floppy drive into place into slot 2. 8 Align the shoulder screws with the screw guides, and slide the drive into Desktop Computer Parts 235