Dell PowerConnect 5548 User Guide - Page 664

2 For each DSCP In value (DSCP value of the incoming packet) that needs to be rewritten to an alternative value, set a DSCP Out value. Assigning DSCP Rewrite Values Using CLI Commands The following table summarizes the CLI commands for configuring fields in the DSCP Rewrite page. Table 22-9. DSCP Rewrite CLI Commands CLI Command qos map dscp-mutation indscp to out-dscp no qos map dscp-mutation [in-dscp] Description Configures the DSCP to DSCP Mutation table. Use the no form of this command to restore the default configuration. The following is an example of the CLI commands: console(config)# qos map dscp-mutation 1 2 4 5 6 to 63 Interface Settings QoS Trust mode can be configured on each port of the switch, as follows: • QoS Trust State Disabled on an Interface - All inbound traffic on the port is mapped to the best effort queue and no classification/prioritization takes place. • QoS Trust State Enabled on an Interface - Port prioritized traffic on ingress is based on the system- wide configured trusted mode, which is either CoS Trusted mode or DSCP Trusted mode. 664 Dell PowerConnect 55xx Systems User Guide