Dell PowerConnect 5548 User Guide - Page 666
Configuring QoS Basic Mode Using CLI Commands, Assigning Interface Settings Using CLI Commands
View all Dell PowerConnect 5548 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 666 highlights
Assigning Interface Settings Using CLI Commands The following table summarizes the CLI commands for configuring fields in the Interface Settings page. Table 22-10. Interface Settings CLI Commands CLI Command qos trust no qos trust show qos interface[buffers | queueing | policers | shapers | rate-limit] [interface-id]] Description Enables each port trust state while the system is in the basic QoS mode. Use the no form of this command to disable the trust state on each port. Displays QoS information on the interface. The following is an example of the CLI commands: console(config)# interface gi1/0/15 console(config-if)# qos trust Configuring QoS Basic Mode Using CLI Commands The following is a sample script configuring QoS Basic mode. Table 22-11. Sample CLI Script to Configure QoS Basic Mode CLI Command console#configure Description Enable QoS in Basic mode. console(config)# qos basic console(config)#mac access-list extended MAC1 console(config-mac-a1)#deny 00:00:00:00:00:11 00:00:00:00:00:ff any console(config-mac-a1)# permit any any console(config-mac-a1)#exit Define an ACL named "MAC1" MAC1 discards all traffic with source MAC 00:00:00:00:00:XX addresses. MAC1 permits all other traffic. Exit ACL mode. 666 Dell PowerConnect 55xx Systems User Guide