Dell PowerConnect 6024F Command Line Interface (CLI) Guide (.htm) - Page 40
Radius Commands, RIP Commands
View all Dell PowerConnect 6024F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
www.dell.com | support.dell.com class police police aggregate trust set service-policy Defines the traffic classification and enters the policy-map class PM configuration mode. Defines a policer for the classified traffic. PM Applies an aggregate policer to multiple classes within the same policy PM map. Configures the trust state. PM Sets new values in the IP packet. PM Applies a policy map to the interface input. IC Radius Commands Command Group radius-server host radius-server key radius-server retransmit radius-server source-ip radius-server timeout radius-server deadtime show radius-servers Description Specifies a RADIUS server host. Sets the authentication and encryption key for all RADIUS communications between the router and the RADIUS daemon. Specifies the number of times the software searches the list of RADIUS server hosts. Specifies the source IP address used for communication with RADIUS servers. Sets the interval for which a router waits for a server host to reply. Improves RADIUS response times when servers are unavailable. Displays the RADIUS server settings. Mode GC GC GC GC GC GC UE RIP Commands Command Group router rip enable router rip redistribute ospf router rip redistribute static rip rip passive-interface rip auto-send rip version Description Enables the RIP on the device. Advertises routes learned by OSPF in the RIP process. Advertises routes statically learned in the RIP process. Creates a Routing Information Protocol (RIP) process on an interface. Disables the sending of routing updates on an interface. Automatically detects if RIP information is required to be sent on the interface. Specifies a RIP version. Mode GC GC GC IC IC IC IC 40 Command Groups