Dell PowerConnect 6024F Command Line Interface (CLI) Guide (.htm) - Page 90
bridge multicast forward-all
View all Dell PowerConnect 6024F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
www.dell.com | support.dell.com Syntax bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} {add | remove} {ethernet interface-list | port-channel port-channel-number-list} no bridge multicast forbidden address {mac-multicast-address | ip-multicast-address} • add-Adds ports to the group. • remove-Removes ports from the group. • mac-multicast-address-MAC Multicast address. • ip- multicast-address-IP Multicast address. • interface-list-Separate non consecutive valid Ethernet ports with a comma and no spaces; hyphen is used to designate a range of ports. • port-channel-number-list-Separate non consecutive valid port-channels with a comma and no spaces; a hyphen is used to designate a range of port-channels. Default Configuration No forbidden addresses are defined. Command Modes Interface Configuration (VLAN) mode User Guidelines Before defining forbidden ports, the Multicast group should be registered. Examples In this example the MAC address 0100.5e02.0203 is forbidden on port g9 within VLAN 8. Console (config)# interface vlan 8 Console (config-if)# bridge multicast address 0100.5e02.0203 Console (config-if)# bridge multicast forbidden address 0100.5e02.0203 add ethernet g9 bridge multicast forward-all The bridge multicast forward-all interface configuration command enables forwarding of all Multicast packets on a port. To restore the default, use the no form of the bridge multicast forward-all command. Syntax bridge multicast forward-all {add | remove} {ethernet interface-list | port-channel portchannel-number-list} 90 Address Table Commands