Dell PowerConnect 6224P Release Notes - Page 15
IP Multicast Static Route Configuration - powerconnect 6224 vlan
View all Dell PowerConnect 6224P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 15 highlights
PowerConnect 6224/6224F/6224P/6248/6248P Release Notes ¾ Trap Configuration In previous versions of the software, configuration of the flags for controlling traps was scattered about in a number of places. snmp-server enable traps is now a common command for configuring all trap flags. The legacy commands are preserved for backward compatibility. Also note that the keyword "trap" has changed to the plural "traps". ¾ SNTP Server Priority The server priority is now available from the show sntp configuration command. Previously it was only configurable. ¾ GARP Leave Timer The valid range for the GARP leave timer has been changed to 20-600 centiseconds. ¾ IP Multicast Static Route Configuration The command for configuring a static IPv4 multicast route has changed to ip mroute. The ip multicast staticroute command is deprecated. ¾ Support for Long User Names The show users, show users accounts, and show users login-history commands have changed. The long parameter has been added to these commands to support long usernames. ¾ Flow Control Flow Control is enabled by default. Note: When you upgrade a switch to this release, flow control is automatically enabled. If your previous configuration had flow control disabled, you must disable flow control after the upgrade to match the previous configuration. ¾ VLAN Limit Increases MAC based VLAN limit was increased from 128 to 256. Subnet based VLAN limit was increased from 64 to 128. System Firmware Version 3.2.0.6 Page 13