Dell PowerConnect 6224P Release Notes - Page 20

Description Bridge multicast forbidden forward-unregistered causes L3 Multicast to fail. Cut-through mode command help is not clear. Console logging levels help does not indicate precedence. Web Dot1x Authentication Max Users show units in seconds vs. # Users. Web and CLI disagreement on Dot1x statistics. ReFormatFlashFileSystem no available via the boot menu. Show interfaces advertise ethernet command is not parsed properly. Stack port link status mismatch in CLI and Web interface when configured for Ethernet. Web Home > General > Asset selection does not show details. Mirroring port should not send CDP packets. Backups with SNMP do not work correctly. END command with all upper case is not understood by CLI. Trying to add ninth member to a channel-group shows LACP assignment in HTTP view. Switchport protected name accepts non-alphanumeric characters. Description inconsistency between HTTP and CLI Administration. Inconsistent CLI and Web interface responses for STP LAG settings. Ip host parse User Impact Flooding in ingress VLAN. For normal command and no command the help information is the same. Help content needs to show severity level of logging. Incorrect help string added in read-only page of dot1x, causing user confusion. Not displaying the MAC address correctly in the field Last Frames Source in the web page EAP Statistics. ReFormatFlashFileSystem cannot be executed from boot menu. Show interfaces advertise ethernet command is not parsed properly. To display the correct link status when configured stack mode is Ethernet in the Stack Port Summary web page. Incorrect link for Asset page on General Index page. Both mirrored and mirroring ports are sending CDP packets. The MIB allows users to backup the starting configuration to TFTP using SNMP, but the file is corrupted. User will not be able to go to root mode by entering END. Trying to add ninth member to a channelgroup shows LACP assignment in HTTP view. Needed to check that protected port name accepts only alphanumeric characters. Spaces were not accepted in description fields through web. Inconsistent CLI and Web interface responses for STP LAG settings. Some ip host names with numbers and periods are rejected. Resolution Modified the L3 interaction code of snooping to notify the driver when snooping is enabled. When snooping is disabled, the current operational state of snooping is also sent to the driver. Changed the help information Added the severity levels to the help strings. Removed help string for read-only page of dot1x. Corrected the problem in the object handler. The ReFormatFlashFileSystem operation is now available via the boot menu. Added a check for invalid interface. Corrected the web page to properly handle Ethernet and show link status as up. Corrected the file name for the Asset page. Get probe events, and mark interface as acquired in ISDP database. As a result, ISDP does not participate on this port. Corrected handling of upload filetypes and setting local filename in SNMP. Use case insensitive comparison. Corrected the code to enable LACP after ports are added to lag successfully. Enhanced the validation. Added appropriate validation. Use the CLI formatting such that both the CLI and Web are in sync. Corrected the host name checks. 18 System Firmware Version 3.2.0.6