Dell PowerConnect 6224P Release Notes - Page 28
Summary, User Impact, Workaround, show running, config
View all Dell PowerConnect 6224P manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 28 highlights
Summary Bridge multicast address is shown as MAC Address format in show runningconfig buffer when it is configured in IP format. Connected spanning tree root port role not changed to autoportfast after disabling MSTP on Trunk. Three commands are not available at interface range Ethernet level, but are available at interface. There is no command to add protocol vlan in interface range mode. Invalid error port number displayed on log message when VLAN is changed to forbidden mode from access mode. User Impact If a user configures the bridge multicast address as an IP address format in VLAN interface mode, it is displayed in the show running-config command in MAC address format. A port that is a root port will not become auto edge port if the bridge that the root port is connected to goes away. The following commands are not available to use in interface range Ethernet level: isdp, lacpa, and protocol. The user cannot use interface ranges to configure a protocol VLAN. When port is changed to forbidden mode from access mode, the log message below is generated that reports the wrong port number. OCT 12 08:39:03 10.131.6.173-1 DOT1Q[104741168]: dot1q_api.c(525) 2475 %% Port(88) Workaround None. This means that the port would flush the Forwarding Database entries every time that there is a topology change. This could be avoided if the link goes down and comes back up. Each interface must be configured individually. Each protocol VLAN must be configured individually. None. Gratuitous ARP packets are not being generated when management VLAN is changed with static IP configuration. Using interface range mode not able to configure protected ports. TFTP fails to display specific error message when incorrect filename was given while downloading the code. Web needs to provide an option to configure sFlow sampler / poller values on range of interfaces. This log message is correct when a port from the base unit is selected. If the user changes the management VLAN, then management connections must be reestablished on the new VLAN. Neighbors will resolve the switch's management IP address on the new VLAN. Cannot use interface range mode to configure protected switchports. If a user attempts to tftp a non-existent file to the image of the switch, nothing will be downloaded and there will not be an error message generated. User will not be able to select range of interfaces through web for the Sampler and Poll Configuration web pages. However, configuration is not affected as user can individually select the interfaces and configure. None. The user must configure each protected port individually. None. User has to select each interface individually to configure in the Sampler Configuration and Poll Configuration web pages. 26 System Firmware Version 3.2.0.6