Dell PowerConnect 6224P Release Notes - Page 21

PowerConnect 6224/6224F/6224P/6248/6248P Release Notes Description Cannot enter Daylight Saving Time from Web interface. Error message when changing SNTP Server Priority from Web interface. Custom Protocol VLAN shows incorrect VLAN ID. NIM_events prints unknown characters. VLAN protocol groups not visible in GUI. Second protocol group not shown in OpenManage GUI. Adding VLAN range issues. Switch gives error message when entered upper case letter for interface value. Custom Protocol-based VLAN does not display configurable ethertype value. Captive Portal login does not display error message for invalid credentials. OpenManage Web UI shows invalid MAC address (all 0s) in ARP table. Unable to authenticate a client when radius server is given a name User Impact In summer time configuration page, in recursive mode, clock zone field is not accepting valid range. When priority is set through Web interface for SNTP Server, and no encryption key is configured, the system returns an error message. VLAN protocol group if configured for custom protocol using ethertype did not display the VLAN id in the Switching > VLAN > ProtocolGroup web page. Unknown characters being displayed are for the interface name. MAY 26 05:57:54 0.0.0.0-3 NIM[99904544]: nim_events.c(603) 367 %% Component NIM generated interface event Unknown Port Event (39) for interface ?j?????? (639). Cannot select the protocol group on the Switching > VLAN > ProtocolGroup web page. In protocol-based VLAN Show All page, configured interfaces were not displayed properly. Web page affected Switching > VLAN > Protocol Group Table. 1. When adding a range of VLANs to VLAN Database from Web Interface, an error message is returned when no name is entered. 2. VLAN range is limited to 4 characters preventing adding certain ranges. On the interface ethernet CLI command, switch gives error message when entering interface names in upper case letters. Valid range of supported ethertypes is not mentioned in CLI help. Captive Portal user can get confused since the login failure is not reported correctly. Configuring Proxy ARP results in the ARP Table web page displaying the MAC address as all zeros. User authentication does not happen when there is no default radius server. Resolution In summer time configuration page, in recursive mode, added appropriate regular expression in validation. Upon setting the priority to SNTP server when no encryption key is configured, the key is now submitted to the switch. Made modifications to the Switching > VLAN > ProtocolGroup web page in order to resolve the issue. Properly initialized the variable. Display the group IDs in the list and corresponding group name below it. Corrected the display of the interfaces. 1. Corrected the error handling for this scenario. 2. Increased the maximum length to 250 such that a comma separated VLAN list can be configured. String is converted to lower case before processing. Add supported range in CLI help. Implemented logic that verifies the session state. Corrected the output of the MAC Address in the ARP Table to be the same as the Dynamic Address Table web page. The switch was assuming that the default named radius server will always be present. Therefore, when no default named server is present the switch will attempt to send it to the next valid radius server. System Firmware Version 3.2.0.6 Page 19