Dell PowerConnect 6224P Release Notes - Page 24

Title show ip ospf neighbor Description This command has been enhanced to list the per neighbor graceful restart status described in the RFC 4750 MIB. Possible values for Restart Helper Status are as follows: • Helping - This router is acting as a helpful neighbor to this neighbor. • Not Helping - This router is not a helpful neighbor at this time. Port Configuration Show Command Title show interfaces detail {ethernet interface | portchannel port-channel-number} Description A new single command that shows VLAN, STP, Port status, and Port Configuration information. Default: Not applicable Custom Protocol Based VLANs Title vlan protocol group add protocol ethertype no vlan protocol group add protocol ethertype vlan protocol group no vlan protocol group Description Previously only ARP, IP and IPX are configurable as protocols for protocol-based VLANs. This has been extended so that any Ethertype may be used. • groupid-The protocol-based VLAN group ID, which is automatically generated when you create a protocol-based VLAN group with the vlan protocol group command. To see the group ID associated with the name of a protocol group, use the show port protocol all command. • ethertype-The protocol you want to add. The ethertype can be any valid hexadecimal number in the range 1536 to 65535. Default: Not applicable If the user creates multiple vlan protocol groups, deletes one of them, and then saves the configuration, the older implementation of this command resulted incorrectly applying the groupids on reload. Hence, the existing command vlan protocol group is updated to vlan protocol group so that groupid is used for both configuration and script generation. • groupid-The protocol-based VLAN group ID, to create a protocolbased VLAN group. To see the created protocol groups, use the show port protocol all command. vlan protocol group name no vlan protocol group name Default: Not applicable This is a new command for assigning a group name to vlan protocol group id. • groupid-The protocol-based VLAN group ID, which is automatically generated when you create a protocol-based VLAN group with the vlan protocol group command. To see the group ID associated with the name of a protocol group, use the show port protocol all command • groupName-The group name you want to add. The group name can be up to 16 characters length. It can be any valid alpha numeric characters. Default: Not applicable VLAN Name Support with RADIUS Server Title show dot1x Ethernet interface Description The command was updated to display the VLAN Id, or name as required. Default: Not applicable 22 System Firmware Version 3.2.0.6