Dell PowerConnect OpenManage Network Manager Release Notes 5.0 - Page 13

13 • If you use the "backup to flash" option when backing up configuration files, the filename must have the extension *.tar.gz.If not, restore fails with a "failed to decompress" error. (15283) • 55xx devices echo command lines sent to them, so Adaptive CLI commands display echoed characters in their Audit Trails. This is not an error and does not mean the configuration failed. (14796) • Upgrading from switch to router firmware on an FCX device upgrades an L2 Switch with L3 firmware, so the IP commands/configuration changes and the L2 configuration are ignored. The device needs to be reconfigured from the console. (14369) • M8024-K does not support ethernet link discovery unless you update the firmware to 4.2. (14853) • PowerConnect 62xx users must be running 3.x.x.x firmware (or later) on their switch before they can do a standard firmware upgrade. Attempting to upgrade the firmware while at version 2.x or 1.x fails. To upgrade from these versions, see the special instructions provided in the Release Notes and Readme for the firmware itself. (8507) • OMNM receives all data from the Dell 62xx device, but if the Last Update day is more than a single digit, then the entire data table disappears, and OMNM displays a Form Error. One other symptom: the Last Update, Total Inserts, Total Deletes, Total Drops, and Total Ageouts do not appear correct, as they are in the CLI. Workaround: Rebooting switch sets the Last Update back to zero. Once done, the LLDP Stats works again. (8213) • Cable Tests on ports in a stack may fail, producing the message Test has not been preformed. Workaround: Make sure the management (master) switch is set to Unit-1 in the stack. (8129) • Some discrete configuration (Resource editor) screens do not appear or are inoperable in Web client. • Stacked switches change IP addresses when the master is moved. Moving master does not function properly in stack configuration. (7002) • When editing any interface set to disabled mode, and choosing vlan tagging from the combo box, you will not be able to add a VLAN ID. The field is grayed out. Workaround: Switch the selection to another item and then back to the desired one. (6355) • You must use the command-line interface to deploy new firmware for the 5324 model (4739) • LLDP modification through this application may not work on M8024 devices, therefore you must setup LLDP through the telnet CLI. (2583) • When one of the three banners already configured on a 35xx or 54xx device is longer than 500 characters, you must modify that banner in OMNM before you can create a different banner. (2411) • If directory locks during upgrade, check task manager and close all ftp.exe processes.(2455) • Web client does not show IPv6 information when older firmware is installed on the switch. (2967) • OSPF Areas cannot be deleted for M6220 devices. (44464)