Dell PowerConnect W-AP124 Dell PowerConnect AP-120-MNT-WJ Access Point Enclosu - Page 3

2. To install the AP enclosure on a ceiling rail: a. Pull the necessary cables through a prepared hole in the ceiling tile near where the AP will be placed. The prepared hole must line up with the cable pass-through in the base plate. b. (Optional) if the ceiling rail is 9/16", install the ceiling rail adapter (Figure 3). c. Hold the enclosure base next to the ceiling rail with the ceiling rail at approximately a 30-degree angle to the ceiling tile rail (Figure 3). d. Rotate the enclosure base clockwise until the device clicks into place on the ceiling rail. Figure 3 Installing the AP on a ceiling rail Ceiling tile rail Rotate AP until it clicks into place Align tabs with rail Ceiling tile APenc_008 Installing 9/16" Rail Adapter 3. Connect the Ethernet cable to Ethernet port 0 on the AP. Hold the unused cables down and to the right of the screw post as you continue with the next step. 4. Attach the AP to the mounted base plate as follows: a. Position the antennas on the AP along the sides of the unit. b. Locate the mounting posts on the base plate and the mounting holes on the AP (Figure 4). Figure 4 Preparing to attach the AP Mounting Posts AP-120-MNT-WJ Access Point Enclosure | Installation Guide APenc_004 Mounting Holes 3