Dell PowerEdge 1900 Installing a SATA Optical Drive - Page 7

Figure 1-3. SATA Cable Routing in the PowerEdge 1950 2 1 3 4 6 5 1 SATA data cable 3 chipset shroud 5 SATA power cable 2 SATA_A connector on system board 4 system fans 6 optical drive 5 Reinstall the SAS controller daughter card and reconnect the SAS cable. See "SAS Controller Daughter Card" in your Hardware Owner's Manual. 6 Close the system. See "Closing the System" in your Hardware Owner's Manual. 7 Reconnect the system to power and turn on the system and attached peripherals. Installing the SATA Optical Drive - PowerEdge 2970 or 2950 1 Insert the optical drive tray into the system until it is fully inserted and locked into position. 2 Connect the SATA cable (the end with the branching power cable) to the back of the optical drive. 3 Connect the branching power cable to the power supply connector. Installing a SATA Optical Drive 7