Dell PowerEdge C8000 Dell PowerEdge C8220X Hardware Owner's Manual - Page 250
Removing and Installing the Node Power Distribution Board
View all Dell PowerEdge C8000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
9 Disconnect all cables from the NPDB. See Figure 3-81. When you disconnect the power cable, press down the cable-locking tab and disconnect the power cable from the NPDB. Note the routing of the cable underneath the tabs on the sled as you remove them from the sled tray. You must route these cables properly when you replace them to prevent the cables from being pinched or crimped. 10 Remove the four screws securing the NPDB to the NPDB assembly. See Figure 3-81. 11 If necessary, press the retaining clip outward to unlock the node power distribution board. 12 Lift the NPDB out of the NPDB assembly. See Figure 3-81. Figure 3-81. Removing and Installing the Node Power Distribution Board 1 screws (4) power cables 3 power cable 5 node power distribution board 7 power cable 2 emergency throttling cable 4 power cable 6 power cable 8 power cable 250 Installing System Components