Dell PowerEdge T40 EMC Technical Specifications Guide - Page 10

Table 5. Expansion card slots supported on the system board PCIe slot Slot Type Processor Connection Slot 1 PCIe x16 Gen3 Processor Slot 2 PCI Platform Controller Hub Slot 3 PCIe x4 Gen 3 (open ended) Platform Controller Hub Slot 4 PCIe x4 Gen 3 (open ended) Platform Controller Hub PCIe slot height Full Height Full Height Full Height Full Height Maximum Add-in Card Length Half length Half length Half length Half length NOTE: The expansion cards are not hot swappable. Memory specifications CAUTION: Dell recommends you to use ECC DIMMs to minimize the risk of uncorrectable system error, data loss and/or silent data corruption. Non-ECC DIMM is not used for mission-critical applications. NOTE: Non-ECC DIMMs are supported only in selected countries, for more information contact your sales representative. Table 6. Memory specifications DIMM Type UDIMM, DDR4, ECC/Non-ECC DIMM capacity 8 GB 16 GB Minimum RAM 8 GB 16 GB Maximum RAM 32 GB 64 GB Storage controller specifications The PowerEdge T40 system supports Intel Virtual RAID on CPU (Intel VROC) software RAID. NOTE: Intel VROC supports RAID modes 0, 1, 5, and 10. NOTE: The PowerEdge T40 system does not support RAID 10 as RAID 10 is supported only on systems with 4 drives. Drive specifications Drives The PowerEdge T40 system supports the following drive configurations: Table 7. Drive configurations Configuration Up to 3 x 3.5-inch drive cabled SATA drives. Capacity 1 / 2 / 4 TB NOTE: The PowerEdge T40 system only supports entry drives. Entry Drives : Least expensive drives used in applications where low usage and limited total number of drives are applicable. Due to restrictions on use, these drives are available in a small number of systems and configurations. 10 Technical specifications