Dell PowerSwitch S4820T Configuration Guide for the S4820T System 9.112.0P1 - Page 484

To disable a specific debug command, enter the keyword no then the debug command. For example, to disable debugging of IS-IS updates, use the no debug isis updates-packets command. To disable all IS-IS debugging, use the no debug isis command. To disable all debugging, use the undebug all command. IS-IS Metric Styles The following sections provide additional information about the IS-IS metric styles. • Configuring the IS-IS Metric Style • Configure Metric Values Dell Networking OS supports the following IS-IS metric styles: • narrow (supports only type, length, and value [TLV] up to 63) • wide (supports TLV up to 16777215) • transition (supports both narrow and wide and uses a TLV up to 63) • narrow transition (accepts both narrow and wide and sends only narrow or old-style TLV) • wide transition (accepts both narrow and wide and sends only wide or new-style TLV) Configure Metric Values For any level (Level-1, Level-2, or Level-1-2), the value range possible in the isis metric command in INTERFACE mode changes depending on the metric style. The following describes the correct value range for the isis metric command. Metric Style wide narrow wide transition narrow transition transition Correct Value Range for the isis metric Command 0 to 16777215 0 to 63 0 to 16777215 0 to 63 0 to 63 Maximum Values in the Routing Table IS-IS metric styles support different cost ranges for the route. The cost range for the narrow metric style is 0 to 1023, while all other metric styles support a range of 0 to 0xFE000000. Change the IS-IS Metric Style in One Level Only By default, the IS-IS metric style is narrow. When you change from one IS-IS metric style to another, the IS-IS metric value (configured with the isis metric command) could be affected. In the following scenarios, the IS-type is either Level-1 or Level-2 or Level-1-2 and the metric style changes. 484 Intermediate System to Intermediate System