Dell PowerVault 200S Dell PowerVault 2xxS Storage Systems SCSI Backplane Board - Page 14
SCSI Backplane Board Replacement Completion - powervault 210s
View all Dell PowerVault 200S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 14 highlights
. lock bar key lock Figure 14. Installing the Lock Bar (System Shown with a Removable Lock Bar) 5. Place the key in the keylock and turn it to the locked position. Remove the key from the keylock. SCSI Backplane Board Replacement Completion NOTE: For information on installation, cabling, and powering on the storage system, see the Dell PowerVault 200S, 201S, 210S, and 211S Storage Systems Installation and Service Guide. After replacing the SCSI backplane board, complete the procedure by performing the following steps: 1. Install the storage system in the rack from which it was removed. If the storage system was used in a stand-alone configuration, install the storage system in the stand-alone enclosure. 2. Connect the communication cable(s) coming from the host computer to the storage system. 3. Connect the power cable(s) from the storage system to the power source(s). 4. Turn on the storage system. 14 Dell PowerVault 2xxS Storage Systems SCSI Backplane Board Replacement Instructions