Dell PowerVault 200S Dell PowerVault 2xxS Storage Systems SCSI Backplane Board - Page 4
Remove the Power Supplies - replacement drive
View all Dell PowerVault 200S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 4 highlights
Slowly pull the carrier toward you until it slides free of the drive bay. Figure 3. Drive Carrier Lock Figure 4. Drive Carrier Handle Remove the Power Supplies NOTICE: In a nonredundant system, note the location of the power supply and the power-supply blank as you remove them from the power-supply bays. During the installation procedure (found later in this document), you must return the power supply and the powersupply blank to the same power-supply bays from which they were removed. NOTE: A redundant storage system has two power supplies. A nonredundant storage system has one power supply and one power-supply blank. Because a power supply and a power-supply blank are removed in the same manner, both components are referred to as a power supply in this procedure. To remove the power supplies from the storage system, perform the following steps: 4 Dell PowerVault 2xxS Storage Systems SCSI Backplane Board Replacement Instructions