Dell PowerVault MD3200i CLI Guide - Page 176
Reset RAID Controller Module
View all Dell PowerVault MD3200i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 176 highlights
Parameters Parameter physicalDisk physicalDisk (wwID) replacementDrive Description Specifies the physical disks to assign to the virtual disk that you want to create. Specify the tray ID and slot ID for each physical disk that you assign to the virtual disk. Tray ID values are 0 to 99. Slot ID values are 0 to 31. You must put brackets ([ ]) around the tray ID value and the slot ID value. The World Wide Identifier (WWID) of the physical disk that you want to replace. You can use the WWID instead of the virtual disk name to identify the virtual disk. Enclose the WWID in angle brackets (< >). Specifies the physical disks to assign to the virtual disk that you want to create. Specify the tray ID and slot ID for each physical disk that you assign to the virtual disk. Tray ID values are 0 to 99. Slot ID values are 0 to 31. Reset RAID Controller Module This command resets a RAID controller module. NOTE: When you reset a RAID controller module, the RAID controller module is not available for I/O operations until the reset is complete. If a host is using virtual disks owned by the RAID controller module being reset, the I/O directed to the RAID controller module is rejected. Before resetting the RAID controller module, either verify that the virtual disks owned by the RAID controller module are not in use or ensure a multipath driver is installed on all hosts using these virtual disks. Syntax reset controller [(0 | 1)] 176 Script Commands