Dell PowerVault MD3200i CLI Guide - Page 250
Start iSCSI DHCP Refresh
View all Dell PowerVault MD3200i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 250 highlights
Parameter Parameter enclosure Description Identifies the enclosure to blink. Enclosure ID values are 0 to 99. You must put brackets ([ ]) around the enclosure ID value. Start iSCSI DHCP Refresh This command initiates a refresh of the DHCP parameters for the iSCSI interface. If the configuration method for the interface is not set to DHCP, the procedure returns an error. Syntax start controller [(0 | 1)] iscsiHostPort [(1 | 2 | 3 | 4)] dhcpRefresh Parameters Parameter Description controller The identifier letter of the RAID controller module that has the iSCSI host ports. Valid RAID controller module identifier values are 0 or 1, where, 0 is the RAID controller module in slot 0, and 1 is the RAID controller module in slot 1. iscsihost-port The identifier of the port on the storage array on which you want to refresh the DHCP parameters. Enclose the iSCSI host port name in square brackets ([ ]). NOTE: This operation ends the iSCSI connections for the portal and brings down the portal temporarily. 250 Script Commands