Dell PowerVault MD3260 CLI Guide - Page 178
force=TRUE | FALSE], writeMode=synchronous | asynchronous
![]() |
View all Dell PowerVault MD3260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 178 highlights
virtualDiskNameN]) role=(primary | secondary) [force=(TRUE | FALSE)] syncPriority=(highest | high | medium | low | lowest) autoResync=(enabled | disabled) writeOrder=(preserved | notPreserved) writeMode=(synchronous | asynchronous) Parameters Parameter localVirtualDisk or localVirtualDisks Description The name of the primary virtual disk for which you want to define properties. You can enter more than one primary virtual disk name. Enclose the primary virtual disk name in square brackets ([ ]). If the primary virtual disk name has special characters, enclose the primary virtual disk name in double quotation marks (" "). role The setting for the virtual disk to act as the primary virtual disk or the secondary virtual disk. To define the virtual disk as the primary virtual disk, set this parameter to primary. To define the virtual disk as the secondary virtual disk, set this parameter to secondary. This parameter applies only when the virtual disk is part of a replication relationship. force syncPriority autoResync The role reversal is forced if the communications link between the storage arrays is down and promotion or demotion on the local side results in a dual-primary condition or a dual-secondary condition. To force a role reversal, set this parameter to TRUE. The default value is FALSE. The priority that full synchronization has relative to host I/O activity. Valid values are highest, high, medium, low, or lowest. The settings for automatic resynchronization between the primary virtual disks and the secondary virtual disks of a remote replication pair. This parameter has these values: • enabled-Automatic resynchronization is turned on. You do not need to do anything further to resynchronize the primary virtual disk and the secondary virtual disk. • disabled-Automatic resynchronization is turned off. To resynchronize the primary virtual disks and the secondary virtual disk, you must run the resume remoteReplication command. writeOrder This parameter defines write order for data transmission between the primary virtual disk and the secondary virtual disk. Valid values are preserved or notPreserved. 178
![](/manual_guide/products/dell-powervault-md3060e-cli-guide-d192876/178.png)