Dell PowerVault MD3260 CLI Guide - Page 198
Show Remote Replication Virtual Disk Candidates
View all Dell PowerVault MD3260 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 198 highlights
NOTE: Use the show controller NVSRAM command to display parts or all of the NVSRAM before using the set controller command to change NVSRAM values. Show Remote Replication Virtual Disk Candidates NOTE: This command valid only with Fibre Channel storage arrays. This command returns information about the candidate virtual disks on a remote storage array that can be used as secondary virtual disks in a Remote Replication configuration. Syntax show remoteReplication candidates primary= "virtualDiskName" remoteStorageArrayName=storageArrayName Parameters Parameter primary remoteStorageArrayName Description The name of the local virtual disk that you want for the primary virtual disk in the remote-replicated pair. Enclose the primary virtual disk name in double quotation marks (" "). The remote storage array that contains possible virtual disks for a secondary virtual disk. If the remote storage array name has special characters, it must be enclosed in double quotation marks (" "). Show Remote Replication Virtual Disk Synchronization Progress NOTE: This command valid only with Fibre Channel storage arrays. This command returns the progress of data synchronization between the primary virtual disk and the secondary virtual disk in a Remote Replication configuration. This command shows the progress as a percentage of data synchronization that has been completed. Syntax show remoteReplication (localVirtualDisk ["virtualDiskName"] | localVirtualDisks ["virtualDiskName1" ... "virtualDiskNameN"]) Parameter Parameter localVirtualDisk or localVirtualDisks Description The name of the primary virtual disk of the remote replication pair for which you want to check synchronization progress. Enclose the primary virtual disk name in double quotation marks (" ") inside square brackets ([ ]). 198