Dell Precision 400 User's Guide (.pdf) - Page 120
Adding an Unlisted Card in for, puter. See Removing a Card
View all Dell Precision 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
Table C-1. Configuration Utility Messages (continued) Message Probable Cause Corrective Action The ICU detects a resource conflict between this card and conflicting_card. The conflicting resource was: resource. You added or modified a card that now requires a resource value already in use by conflicting_card. Try each of the following options until the problem is resolved: • Modify the card you are adding so that it uses a different value for resource. See "Modifying a Card" in Chapter 4 for instructions. • Modify conflicting_card so that it uses a different value for resource. See "Modifying a Card" in Chapter 4 for instructions. • If conflicting_card is not the system board or riser board, remove it from the computer. See "Removing a Card" in Chapter 4 for instructions. • Remove all expansion cards from the ICU, and then add them back one at a time, beginning with the new card and resolving resource conflicts as they arise. See "Removing a Card" and "Adding a Listed Card" or "Adding an Unlisted Card" in Chapter 4 for instructions. • If you cannot resolve the resource conflict by any of the preceding methods, remove the new card. If you were modifying an existing card, reset the modified card to its previous resource value. NOTE: For the full name of an abbreviation or acronym used in this table, see the Glossary. C-4 Dell Workstation Midsize Systems User's Guide