Dell S3100 Command Line Reference Guide for the Series 9.112.0P2 - Page 1207

Defaults Command Modes Command History Enabled, that is sending of routing updates are enabled by default. ROUTER OSPF for OSPFv2 ROUTER OSPFv3 for OSPFv3 This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.2(1.0) 9.1.(0.0) 8.3.19.0 7.8.1.0 7.4.1.0 Description Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the Z9500. Introduced support for OSPFv3 on the S4810 and Z9000. Introduced on the S4820T. Added support for the C-Series. Introduced on the E-Series. Usage Information By default, no interfaces are passive. Routing updates are sent to all interfaces on which the routing protocol is enabled. If you disable the sending of routing updates on an interface, the particular address prefix continues to be advertised to other interfaces, and updates from other routers on that interface continue to be received and processed. OSPFv3 for IPv6 routing information is not sent or received through the specified router interface. The specified interface address appears as a stub network in the OSPFv3 for IPv6 domain. On configuring suppression using the passive-interface command, the state of the OSPF neighbor does not change to INIT; instead, the state of the OSPF neighbor changes to DOWN after the dead-timer expires. redistribute Redistribute into OSPFv3. Syntax redistribute {bgp as number}{connected | static}[metric metric-value | metrictype type-value] [route-map map-name] [tag tag-value] To disable redistribution, use the no redistribute {connected | static} command. Open Shortest Path First (OSPFv2 and OSPFv3) 1207