Dell S3100 Command Line Reference Guide for the Series 9.112.0P2 - Page 210

To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no deny {ip | ip-protocol-number} {source mask | any | host ip-address} {destination mask | any | host ip-address} command. Parameters ip ip-protocol-number source mask any host ip-address destination count byte log dscp order monitor fragments no-drop Enter the keyword ip to configure a generic IP access list. The keyword ip specifies that the access list denies all IP protocols. Enter a number from 0 to 255 to deny based on the protocol identified in the IP protocol header. Enter the IP address of the network or host from which the packets were sent. Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in A.B.C.D format, may be either contiguous or noncontiguous. Enter the keyword any to specify that all routes are subject to the filter. Enter the keyword host then the IP address to specify a host IP address. Enter the IP address of the network or host to which the packets are sent. (OPTIONAL) Enter the keyword count to count packets that the filter processes. (OPTIONAL) Enter the keyword byte to count bytes that the filter processes. (OPTIONAL, E-Series only) Enter the keyword log to enter ACL matches in the log. (OPTIONAL) Enter the keyword dcsp to match to the IP DCSCP values. (OPTIONAL) Enter the keyword order to specify the QoS priority for the ACL entry. The range is from 0 to 254 (where 0 is the highest priority and 254 is the lowest; lowerorder numbers have a higher priority). If you do not use the keyword order, the ACLs have the lowest order by default (255). (OPTIONAL) Enter the keyword monitor then the session-ID to describe the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. The session-ID range is from 0 to 65535. For more information, see Flow-based Monitoring in the Port Monitoring section in the Dell Networking OS Configuration Guide. Enter the keyword fragments to use ACLs to control packet fragments. Enter the keywords no-drop to match only the forwarded packets. Defaults Command Modes Command History Not configured. CONFIGURATION-EXTENDED-ACCESS-LIST This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.11(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) Description Added support for session-ID to the monitor parameter. Introduced on the S3148. Introduced on the S3100 series. Introduced on the Z9100-ON. 210 Access Control Lists (ACL)