Dell S3100 Command Line Reference Guide for the Series 9.112.0P2 - Page 1742

delay-restore abort-threshold Increase the boot up timer to a value greater than 60 seconds. Syntax delay-restore abort-threshold To remove the boot up timer value, use the no delay-restore abort-threshold command. Parameters interval Enter the interval value (in seconds) for the delay restore timer to abort. The range is from 1 to 1800 seconds. The default is 60 seconds. This delay restore timer applies only during reload/boot-up and not in other scenarios (for example, during ICL flap). Defaults Command Modes Command History 60 seconds VLT DOMAIN This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) 9.10(0.0) 9.8(2.0) 9.8(1.0) 9.8(0.0P5) 9.8(0.0P2) 9.7(0.0) Description Introduced on the S3148. Introduced on the S6100-ON. Introduced on the S3100 series. Introduced on the Z9100-ON. Introduced on the S4048-ON. Introduced on the S3048-ON. Introduced on the S4820T, S4810, S6000, S5000, Z9000, S6000-ON and Z9500. Usage Information To abort the VLT delay restore timer value as the maximum threshold, during reload, apply the maximum time interval to the hold-down ICL peer-up in the start-up configurations. lacp ungroup member-independent Prevent possible loop during the VLT peer switch bootup or on a device that accesses the VLT domain. Syntax lacp ungroup member-independent {vlt | port-channel} Parameters vlt Force all VLT LACP members to become switchports. port-channel Force all LACP port-channel members to become switchports. Defaults Command Modes Command History Not configured. CONFIGURATION This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. 1742 Virtual Link Trunking (VLT)