Dell S3100 Command Line Reference Guide for the Series 9.112.0P2 - Page 238

Example NOTE: Ingress ACLs are supported on C-Series and S-Series platforms only. Dell(conf)# mac-access-list access-list standard TestMAC Dell(config-std-macl)# permit 00:00:00:00:00:00 00:00:00:00:ff:ff count Dell(config-std-macl)# deny any count Dell(config-std-macl)# permit To forward packets from a specific source MAC address, configure a filter. Syntax permit {any | mac-source-address [mac-source-address-mask]} [count [byte]] | [log [interval minutes] [threshold-in-msgs [count]] [monitor] To remove this filter, you have two choices: • Use the no seq sequence-number command if you know the filter's sequence number. • Use the no permit {any | mac-source-address mac-source-address-mask} command. Parameters any mac-sourceaddress mac-sourceaddress-mask count byte log threshold-in msgs count interval minutes monitor Enter the keyword any to forward all packets received with a MAC address. Enter a MAC address in nn:nn:nn:nn:nn:nn format. (OPTIONAL) Specify which bits in the MAC address must match. If no mask is specified, a mask of 00:00:00:00:00:00 is applied (in other words, the filter allows only MAC addresses that match). (OPTIONAL) Enter the keyword count to count packets processed by the filter. (OPTIONAL) Enter the keyword byte to count bytes processed by the filter. (OPTIONAL) Enter the keyword log to include ACL messages in the log. (OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate the maximum number of ACL logs that can be generated, exceeding which the generation of ACL logs is terminated with the seq, permit, or deny commands. The threshold range is from 1 to 100. (OPTIONAL) Enter the keyword interval followed by the time period in minutes at which ACL logs must be generated. The threshold range is from 1 to 10 minutes. (OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you want to monitor and the ACL in which you are creating the rule is applied to the monitored interface. For more information, see "Flow-based Monitoring" in the Port Monitoring section of the Dell Networking OS Configuration Guide. Defaults Command Modes Command History Not configured. CONFIGURATION-MAC ACCESS LIST-STANDARD This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking OS Command Line Reference Guide. Version 9.10(0.0) Description Introduced on the S3148. 238 Access Control Lists (ACL)