Dell S5248F-ON EMC Networking OS10EE FCoE Deployment with FSB - Page 29
S4148U-ON FCF F_Port validation
View all Dell S5248F-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
8 8.1 8.2 8.3 S4148U-ON FCF (F_Port) validation After configuring connected devices, many commands are available to validate the network configuration. This section provides a list of the most common commands and their output for this topology. Note: The following commands and outputs are for the S4148U-F-Port-1. The output for the S4148U-F-Port-2 is similar. For more commands and outputs related to the leaf-spine portion of the topology, such as VLT, and BGP, see Dell EMC Networking Layer 3 Leaf-Spine Deployment and Best Practices with OS10EE. show interface status The show interface status | grep up command is used to verify that the required interfaces are up, and links are established at their appropriate speeds. S4148U-F-Port-1# show interface status | grep up Port Description Status Speed Duplex Eth 1/1/41 up 10G full Fc 1/1/1 up 16G auto Fc 1/1/3 up 16G auto Mode Vlan Tagged-Vlans A 1 - show vlan The show vlan command is used to verify configured VLANs and the interfaces they are applied to. S4148U-F-Port-1# show vlan Codes: * - Default VLAN, M - Management VLAN, R - Remote Port Mirroring VLANs, @ - Attached to Virtual Network Q: A - Access (Untagged), T - Tagged NUM Status Description Q Ports * 1 Active A Eth1/1/9-1/1/26,1/1/29-1/1/54 1001 Active T Eth1/1/41 show fcoe system The show fcoe system command is used to show FCoE-related information. S4148U-F-Port-1# show fcoe system Mode : FPORT FCOE VLAN List (Operational) : 1001 FCFs : 1 Enodes : 4 Sessions : 4 29 Dell EMC Networking OS10EE FCoE Deployment with FSB