Dell STUDIO ONE Setup Guide - Page 33

Using Support Tools NOTE: To replace parts see the Service Manual on the Dell Support website at support.dell.com. One beep - BIOS ROM checksum failure. Possible motherboard failure Contact Dell (see "Contacting Dell" on page 44). Two beeps - No RAM Detected • Remove the memory modules, reinstall one module and restart the computer. If the computer starts normally, reinstall an additional module. Continue until you have identified a faulty module or reinstalled all modules without an error. • If available, install memory modules of the same type in your computer. • If the problem persists, contact Dell (see "Contacting Dell" on page 44). Three beeps - Possible motherboard failure Contact Dell (see "Contacting Dell" on page 44). Four beeps - RAM Read/Write failure • Ensure that no special memory module/ memory connector placement requirements exist (see the Service Manual on the Dell Support website at support.dell.com). • Verify that the memory modules you are installing are compatible with your computer. • If the problem persists, contact Dell (see "Contacting Dell" on page 44). Five beeps - Real Time Clock Failure Replace the battery. System Messages If your computer has an issue or error, it may display a system message that will help you identify the cause and action needed to resolve the issue. NOTE: If the message you received is not listed in the following examples, see the documentation for either the operating system or the program that was running 31