Dell Studio XPS M1340 Service Manual - Page 29
Replacing the Mini-Card
View all Dell Studio XPS M1340 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 29 highlights
4. Remove the screw that secures the Mini-Card to the system board. 5. Lift the Mini-Card out of the system board connector. NOTICE: When the Mini-Card is not in the computer, store it in protective antistatic packaging. For more information, see "Protecting Against Electrostatic Discharge" in the safety information that shipped with your computer. Replacing the Mini-Card 1. Remove the new Mini-Card from its packaging. NOTICE: Use firm and even pressure to slide the card into place. If you use excessive force, you may damage the connector. 2. Insert the Mini-Card connector at a 45-degree angle into the appropriate system board connector. For example, the WLAN card connector is labeled WLAN and so on. 3. Press the other end of the Mini-Card down into the slot on the system board. 4. Replace the securing screw. 5. Connect the appropriate antenna cables to the Mini-Card you are installing. The following table provides the antenna cable color scheme for the MiniCard supported by your computer. Connectors on the Mini-Card WWAN (2 antenna cables) Antenna Cable Color Scheme Main WWAN (white triangle) white with gray stripe Auxiliary WWAN (black triangle) black with gray stripe WLAN (2 antenna cables) Main WLAN (white triangle) white Auxiliary WLAN (black triangle) black WPAN (one antenna cable) WPAN blue 6. Secure the unused antenna cables in the protective mylar sleeve. 7. Replace the base cover (see Replacing the Base Cover). 8. Slide the battery into the battery bay until it clicks into place. 9. Install the drivers and utilities for your computer, as required. For more information, see the Dell Technology Guide. NOTE: If you are installing a communication card from a source other than Dell, you must install the appropriate drivers and utilities. For more generic driver information, see the Dell Technology Guide.