Dell System 200 Owner's Manual - Page 113
Installing Memory
View all Dell System 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
NOTICE: If you remove your original memory modules from the computer during a memory upgrade, keep them separate from any new modules that you may have, even if you purchased the new modules from Dell. If possible, do not pair an original memory module with a new memory module. Otherwise, your computer may not start properly. You should install your original memory modules in pairs either in DIMM connectors 1 and 2 or DIMM connectors 3 and 4. NOTE: Memory purchased from Dell is covered under your computer warranty. Installing Memory CAUTION: Before you begin any of the procedures in this section, follow the safety instructions in the Product Information Guide. CAUTION: Before installing memory, you must remove the PCI Express X16 card. See "Cards" on page 115. NOTICE: To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer's electronic components. You can do so by touching an unpainted metal surface on the computer chassis. 1 Follow the procedures in "Before You Begin" on page 101. 2 Press the securing clip at each end of the memory module connector. 1 2 3 1 memory connector (DIMM_1) 2 securing clips (2) 3 connector Removing and Installing Parts 113