Dell System 200 Owner's Manual - Page 131
Connect the power and data cables to the drive.
View all Dell System 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 131 highlights
1 5 2 6 3 4 1 hard drive 4 system board connector 2 power cable 5 screws (4) 3 serial ATA data cable 6 screw holes in the hard drive bay (4) 6 Replace and tighten the four screws to secure the hard drive. 7 Connect the power and data cables to the drive. 8 Connect the data cable to the system board. 9 Check all cables to be certain that they are properly connected and firmly seated. 10 Replace the computer cover (see "Replacing the Computer Cover" on page 166). NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer. Removing and Installing Parts 131
Removing and Installing Parts
131
6
Replace and tighten the four screws to secure the hard drive.
7
Connect the power and data cables to the drive.
8
Connect the data cable to the system board.
9
Check all cables to be certain that they are properly connected and firmly
seated.
10
Replace the computer cover (see "Replacing the Computer Cover" on
page 166).
NOTICE:
To connect a network cable, first plug the cable into the network port or
device and then plug it into the computer.
1
hard drive
2
power cable
3
serial ATA data cable
4
system board
connector
5
screws (4)
6
screw holes in the hard
drive bay (4)
2
4
3
1
5
6