Dell System 200 Owner's Manual - Page 181
Clearing CMOS Settings
View all Dell System 200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 181 highlights
5 Wait for approximately five seconds to clear the password. 6 Remove the 2-pin jumper plug from pins 1 and 2 and replace it on pins 2 and 3 to enable the password feature. 7 Replace the computer cover (see "Replacing the Computer Cover" on page 166). NOTICE: To connect a network cable, first plug the cable into the network device and then plug it into the computer. 8 Connect your computer and devices to electrical outlets, and turn them on. Clearing CMOS Settings CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide. 1 Follow the procedures in "Before You Begin" on page 101. NOTE: The computer must be disconnected from the electrical outlet to clear the CMOS setting. 2 Remove the computer cover (see "Removing the Computer Cover" on page 103). 3 Reset the current CMOS settings: a Locate the 3-pin CMOS jumper (CLEAR CMOS) on the system board (see "System Board Components" on page 106). b Remove the jumper plug from the CMOS jumper (CLEAR CMOS) pins 2 and 3. c Place the jumper plug on the CMOS jumper (CLEAR CMOS) pins 1 and 2 and wait approximately five seconds. d Remove the jumper plug and replace it on the CMOS jumper (CLEAR CMOS) pins 2 and 3. 4 Replace the computer cover (see "Replacing the Computer Cover" on page 166). NOTICE: To connect a network cable, first plug the cable into the network port or device and then plug it into the computer. 5 Connect your computer and devices to electrical outlets, and turn them on. Appendix 181